Basement & Radon Solutions, BRS Pros, did quite a bit for Jordan, and here is how it went…1. Mold Cleaning- remove all fungus/mold contaminated sub-floor insulation and moisture vapor barrier from the crawl space and dispose of it in the landfill. The crawl space sub-floor wood components will be cleaned and deodorized for wood decaying fungi and organic growth. After cleaning, an EPA registered fungicide is completely fogged throughout the crawlspace. It will kill 99.9% of mold spores and will inhibit the growth of mold and mildew.2. Spray Foam- Class A fire rated polyurethane closed cell spray foam insulation was sprayed on the rim joist and sill plates. It prevents air infiltration and will insulate the wood band plate (rim joist) above the masonry foundation wall.3. Hydra Channel- A clean trench was dug adjacent to the foundation footing along the four interior perimeter foundation wall. The Hydra Channel was then installed adjacent to the footing. The Hydra-Channel engineered fusion welded high strength polyethylene water system will remove storm water up to 70% faster than a pipe and stone system. It will allow water to flow freely to the in-ground sealed sump pump/basin located in the left front interior of the crawl space. 4. Sump Pump- Installed our GrateSump basin with a removeable (flush with floor) lid covered with stone in the left front corner of the crawl space. The system includes 1/3 HP cast iron primary pump with a dual float cage that protects debris from the float. Included is a deluxe controller that monitors the pump and power conditions. It will sound an alarm if problems are detected or a high water warning in the sump. Additionally, it activates the pump weekly to exercise and extend the pumps life.5. Foundation Vents- Foundation vents were completely sealed with poly-foam insulation from the interior of the crawl space. This is preventing exterior air and moisture from coming into the crawl space.6. Blanket Insulation- We install fiberglass blanket insulation to the interior perimeter foundation walls. The insulation is 4 thick which offers an R-13 insulation factor (code compliant for new construction). Insulation was hung approximately 6″ from the top of the interior masonry foundation wall to provide a termite inspection and will cover the wall to approximately 4″ off the ground.7. Liners- “